Lab-Diamond Engagement Rings

As each ring is made to order, our standard production process takes approximately 8 weeks from the order date for completion, plus shipping timeframes. Please keep in mind that we strongly advise clients to wait until they have a confirmed delivery date or better yet, have the ring in hand to make concrete plans for their engagement (such as booking travel, photographers, venues, etc.) especially when deposits are required. 

Since there are multiple factors that go into producing made to order designs, please refer to our production timeline guide for further information. If you have a specific timeline in mind, or any questions regarding our production time frame, please contact us.

Our bandwidths typically vary between 1.5 and 2.2mm which is determined based off of three factors:

• Client's finger size
• Center stone size
• Band type (plain vs pavé)

Consult our bandwidth table below to see our thin, standard, and wide recommendations or contact us to determine the right bandwidth for you! Custom band widths are also available.

Here are two options to help you determine your finger size:

• Option 1: Visit a local jeweler to have your finger measured. This is our preferred method as it ensures the highest accuracy.
• Option 2: Order an inexpensive metal ring sizer online (available on Amazon for example).

Our ring sizes are available in full, half, and quarter size increments, so if you fall in between sizes, we can accommodate!

We always recommend taking precise measurements before placing your order. This step is crucial as resizing rings significantly, up or down, can pose challenges, particularly if your ring features additional stones on the band. 

In case your ring ever requires resizing in the future, you can either resize it through us or through a local jeweler, however resizing is not covered by our warranty, and the fees would be paid out of pocket.

Yes, you can make any necessary adjustments to your design before the CAD (computer design) is approved. Please note that CAD revisions are not taken into account in the production time frame. As such, please expect an extended production timeframe if multiple revisions are requested.

Please consult our full list of FAQs, Resource Guides, and Blog Posts for all the answers to your questions. Otherwise, don’t hesitate to contact us or book a consultation and we’ll be happy to assist!